I can’t remember if I reloaded a previous save or fast traveled out of there, but there is a way to heal down there I believe
I can’t remember if I reloaded a previous save or fast traveled out of there, but there is a way to heal down there I believe
It could be a lot of things. Temperature is a big one, are you letting the bed heat up completely for a consistent amount of time before each print, could heat be impacting your measurements, some things measure different when heated a bit? You probably aren’t printing enclosed, but my voron for example expands upwards almost an entire layer over the first hour of printing. Is there an intermittent air flow that could be impacting how hot your bed really is? Have you verified there is no slop or backlash in your z lead screws and connections? I had decent results on my sidewinder using POM anti backlash nuts. Same for the stability of your measuring tool. Have you checked that it’s not z tilt from turning off the motors between prints?
One I don’t see people mentioning is the walking dead saints and sinners. I haven’t played part 2 yet but I put a lot of hours into the first one
That last point is a big one, for me putting 30 hours into a single VR game feels like putting 100 into a pancake.
It’s been a while since I’ve printed but I think both my sidewinder and voron do this. I don’t remember having it after switching to abs. Painted on supports and wider extrusions helped a ton if I remember correctly. Good luck!