• barsoap@lemm.ee
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    10 months ago

    Do you think that being able to fiddle with your seat position for minutes on end is any way insufficient? Will you ever come close to actually using that feature?

    If you answered those with “no”, then any extra weight and cost is too much. If you answered with “yes” then get a massage chair and leave the poor car be a car. Feature set follows function.

    • piecat@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      10 months ago

      Adding this functionality will:

      Require more IO, add complexity to any wiring harnesses, make repair or replacement more difficult. This all increases cost, probably more than a mass-produced seat motor used by other manufacturers.

      For weight and cost, a proper design would have been negligible. Why do you think every other car isn’t made this way if it comes down to cost?

      • barsoap@lemm.ee
        link
        fedilink
        English
        arrow-up
        1
        ·
        10 months ago

        Require more IO, add complexity to any wiring harnesses, make repair or replacement more difficult.

        None of those: In modern cars you just plug those things into the CAN bus. One connector.

        Why do you think every other car isn’t made this way if it comes down to cost?

        Most cars don’t have seat adjustment motors. And as to others that have that functionality being able to operate it continuously: [citation needed]. Remember these are off the shelf German car supply parts, you’ll find the exact same hardware in, say, a BMW.