Fuck this country.

Moron.

Are you one of those moron who points at a garbage man and says, “Stay in school, or you’ll end up like him” all the while he’s making more than you?

Hey, hey, you get back here

Only if it’s attached with one bolt in the center.

Just my 2 cents, but don’t waste your time. Just get a good sealable tote and pull out the roll to print then put it back. I printed spacers to fit each roll to fit on a 1.5 pvc. Moisture would still wick up the filament and get brittle and break. So I’d have to take it apart to feed the filament and every time a roll ran out, I’d have to take it all apart again. It just all became more work than it was worth. I now use a sealable tote or when I can find them cheap enough Tupperware cake holders.