Same here. Both me and my daughter can’t drink it. It’s terrible. My wife thinks we are insane.

Beautiful town

I am curious how 3 dots in the status bar are a “large problem” for you. Seems weird. If it’s getting in the way of your control panel or notifications, swipe further to the side.

I had an ender 3 as well. Every time I used it I had to calibrate and level it, and watch the the print for the first few layers to make sure it was going to work. I’d estimate it had failed prints around 50% of the time. Eventually it died and I got a anycubic kobra printer. It is so much better it’s unbelievable. I leveled it once when I first assembled it. Since then I haven’t calibrated it or leveled the bed once. I’ve done over 100 prints on it with a 0% failure rate. It is truly a printer where I can tell it to print something and come back 10 hours later and have a perfect print.

I use Avalon in split screen every day

My 2013 does. Not sure what info it gives as I haven’t used it.

Darn, I didn’t see this one yet and I just made one too. At least they are different enough to stand on their own.