I have an Anker Powercore that has enough output to charge the SD while playing, so just wondering what is the most efficient method to get the most out of both power sources for long haul flights.

  • anlumo@feddit.de
    link
    fedilink
    arrow-up
    17
    ·
    1 year ago

    When the SD is discharged, it tries to charge from the external power source (it doesn’t know that it’s a battery and not a charger). Battery to battery charging is just losing energy to heat. So, it’s probably better to discharge the external pack while the SD is at 100%.

        • _TheLoneDeveloper_@sopuli.xyz
          link
          fedilink
          arrow-up
          1
          ·
          1 year ago

          Well actually no, the battery health is counted in charge circles, so if you charge from 0 to 100 it is one charge, if you charge from 50 to 100, then again from 50 to 100 it is again one charge.

          Other than that when you use the battery and let daily to reach 0% it may be over discharged and start creating crystals damaging the battery, the battery would never actually be under 2-5%, but why stress that battery? I’m charging my devices at 20% and it helps with the battery life.

          Also if you want long, healthy batteries you shouldn’t charge to 100 as not to overcharge but who does that?

          • WhiteHotaru@feddit.de
            link
            fedilink
            arrow-up
            1
            ·
            1 year ago

            Apples battery management stops charging at 80%, according to your behavior. If you use the laptop with power connected a lot, it will stop charging and resume later.

  • wizzor@sopuli.xyz
    link
    fedilink
    arrow-up
    15
    ·
    1 year ago

    Many wrong answers here. Most devices have what’s called a power path. When a device is powered via a cable and the battery is full, the device battery is bypassed and the electronics powered via the charging port directly.

    There are always losses in both charging and discharging a battery. Discharging the power bank first and the SD battery second avoids the charging loss from the SD battery.

    You should avoid keeping either battery at sub 20% state-of-charge for long periods, if possible.

    • theCheek@lemmy.worldOP
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      Thanks for the in depth response! So if I understand correctly, it’s better for battery health to use the bank first then the steam deck.

      However if for arguments sake I want to get the maximum amount of play time, would bank first then SD still be the right way to go? I’m asking as perhaps the steam deck uses more power when plugged in as it doesn’t believe it should be preserving charge?

      • wizzor@sopuli.xyz
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Bank first, then SD is good for both max play time and battery health, as the charging of the SD battery results in both energy loss as heat and minute degradation of the battery.

        • andrew@lemmy.stuart.fun
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          Plus then you can recharge the bank, usually at much higher rate than the deck charge rate, and plug it back in before the deck dies with more than 100% of the deck’s capacity.

  • Stephen304@lemmy.ml
    link
    fedilink
    arrow-up
    11
    ·
    1 year ago

    I think you’ll want to minimize using one battery to charge the other since that would cause more losses, so my vote is on keeping the SD full by playing off the external then continuing with the internal battery once the external is empty. That way most/all power goes directly from battery to being consumed.

    • Overzeetop@sopuli.xyz
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      As a bonus, you won’t be stressing the internal battery. An external is far easier to replace than the internal, so plugging in and bypassing the internal battery will extend its life - especially if at the “end” of play you still have at least 30-40% remaining on the internal.

  • sharpiemarker@feddit.de
    link
    fedilink
    arrow-up
    6
    ·
    1 year ago

    No difference either way. Most flights have electrical recepticals under the seats, so you should be able to plug into power regardless.

    As to your original question, you’re going to get the same performance either way. I personally just play the SD on battery and then charge it back up with the battery bank and then play it again.

    • mikehunt@lemmy.world
      link
      fedilink
      arrow-up
      8
      ·
      1 year ago

      I have actually never flown on a narrow body plane that had charging ports, so I wouldnt say “most flights”

      • Overzeetop@sopuli.xyz
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Recently I’ve seen several of the newer Airbus A321s and 737-800s have charging ports and power outlets standard. A couple of low cost carriers (intentionally) omit them, and it seems like a coin flip on the older 737/319/320s, esp for US domestic flights. I’ve taken a couple transatlantic narrowbody flights recently and TAP and Icelandic both had power at the seat. My biggest pet peeve as that, for many flights, you just don’t know until you actually get to your seat.

      • sharpiemarker@feddit.de
        link
        fedilink
        arrow-up
        1
        ·
        1 year ago

        They mentioned it was a “long haul” flight, so I wasn’t clear on exactly what kind of plane. But for most commercial flights, they have those amenities.